Adcom GTP-740 User Manual download pdf (Page 17)

standard (composite) video monitor outputs;

Connect the main monitor or display device to the yellow-center RCA jack

under the “standard monitor 1” label. You may use the "standard monitor 2”

jack for another monitor if desired. Properly connected, either monitor will

then display an image from a video source or on-screen menu information

when appropriate.

CD inputs:

(see illustration on preceding page)

These line-level analog inputs allow easy connection of a CD player (or other two channel

analog audio source.)

Follow these instructions:

1) Connect the CD player’s left channel analog audio output to the GTP-740’s white

“CD in" jack.

2) Connect the CD player’s right channel analog audio output to the red “CD in” jack.

23 S-Video inputs and outputs

Note: This section assumes that you’ve elected to use S-Video sources and display devices

exclusively and that you've set the GTP-740 for S-VIdeo signal transfer by following the steps

described in the boxed note entitled Composite or S-Video? on page 9.

DVD <Sg.»ux <Sg.RF LD

in in in in

VCR video eux momS

in out in out

S-video monitor

1 2

video aux moni2

in out

When hooking up S-Video capable audio/video components, follow the steps outlined in Sections

19 and 22 above. However, ignore the instructions for composite video connections and

substitute the following:

DVD in: Connect the DVD player’s S-VIdeo output to the mini-DIN connector under the S-Video

“DVD in" label.

Dig. aux in: Connect the source’s S-Video output to the mini-DIN connector under the S-Video

“dig. aux in” label.

Dig. RF in: Connect the source’s S-Video output to the mini-DIN connector under the S-Video

“dig. RF in” label.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

No comments

Adcom GTP-740 User Manual Page 17